Kód EPBL_a248 nahlásila ve voze jednotka „Parkovací brzda — vlevo“. Písmeno „a“ uprostřed kódu ho řadí mezi záznamy typu alert.
Levý třmen elektrické parkovací brzdy. Význam kódů odpovídá skupině EPB.
Nejběžnější typ. Vůz si událost zapsal a mohl ji zobrazit na displeji. Škála je široká — od drobnosti, která zmizí sama, po věc, kterou je potřeba řešit.
Takhle je chyba pojmenovaná přímo ve firmware vozu. U kódů bez popisu je to nejpřesnější vodítko, které existuje — název sám říká, čeho se událost týká.
Následující text pochází z technické dokumentace Tesly a necháváme ho v původním anglickém znění, aby se překladem nezměnil význam.
Electronic Parking Brake apply was interrupted during dynamic apply. Apply failed.
Electronic Parking Brake faulted while applying and during ESM_DYNAMIC
Electronic Parking Brake could not be applied, car may be free rolling
Non-nominal termination of external park
Motor current was higher than expected.
Motor current measurement, with calibration offset subtracted, was higher than 17 amps.
Voltage drop on input power is high
Electronic Parking Brake is performing dynamic apply
One or more of the expected CAN messages from TAS were not received.
A message the local ECU expects to receive from the TAS ECU hasn't been received within the expected timeout or the drop rate is too high while the TAS is CAN active. The ECU is considered CAN active when VCFRONT_vehGoToSleep is 0.
All messages the local ECU expects to receive from the TAS ECU are being received or the TAS ECU is CAN inactive.
Air suspension functionality may be missing.
VCLEFT/VCRIGHT: Estimated resistance exceeds 500mOhm when input current is under 15A and exceeds 50mOhm when input current is over 15A. (VC-6540); VCFRONT: Estimated resistance exceeds 100mOhm when input current from PCS is under 10A and exceeds 20mOhm when input current is over 10A.
VCLEFT/VCRIGHT: Estimated resistance is less than 500mOhm when input current is under 15A and is less than 50mOhm when input current is over 15A. (VC-6540); VCFRONT: Estimated resistance is less than 100mOhm when input current from PCS is under 10A and is less than 20mOhm when input current is over 10A.
May result in vehicle becoming inoperable. Note: Service should ignore this alert on VCFRONT for the time being.
Road grade is too steep to secure with Park Brake
Car is parked on a road grade too steep to park; car parked on grade >30% or car with brembo Electronic Parking Brake parked on grade >27% and temperature less than -25degC
Electronic Parking Brake not parked
Car may not be secured by Electronic Parking Brake on the current road grade, may be free rolling
One or more of the expected CAN messages required from DI when not in drive mode were not received.
Opište ho přesně, včetně písmene a čísla. Vyfotit displej je nejjistější — kódy se často liší jen jednou číslicí a záměna vede jinam.
Část kódů zmizí po restartu obrazovky nebo po tom, co vůz nechá pár hodin zamčený. Pokud se kód nevrátí, obvykle šlo o jednorázový výpadek.
Jednorázový záznam a kód, který naskočí po každé jízdě, jsou dvě různé věci. Servisu hodně pomůže, když víte, kdy přesně se objevuje.
Airbagy, brzdy, řízení a vysoké napětí nemá smysl vyčkávat. U ostatních skupin se dá počkat, jestli se kód vůbec vrátí.
Chybové kódy jsou jen jedna část obrázku. U vozů na TesListu vidíte navíc stav baterie stažený přímo z auta a cenovou kalkulačku, která z aktuální nabídky spočítá, co dané auto dneska reálně stojí.